Search Members Help

» Welcome Guest
[ Log In :: Register ]

Mini-ITX Boards Sale, Fanless BareBones Mini-ITX, Bootable 1G DSL USBs, 533MHz Fanless PC <-- SALE $200 each!
Get The Official Damn Small Linux Book. DSL Market , Great VPS hosting provided by Tektonic
Pages: (4) </ [1] 2 3 4 >/

[ Track this topic :: Email this topic :: Print this topic ]

reply to topic new topic new poll
Topic: Solo 2200, Sound and Network Problems< Next Oldest | Next Newest >
colonelpenguin Offline





Group: Members
Posts: 5
Joined: Nov. 2005
Posted: Nov. 02 2005,22:39 QUOTE

I have recently installed DSL on a Gateway Solo 2200.  I was very impressed with how quickly the system installed and now runs on this very old laptop.  However, I have been unable to get my sound working.  It also is not detecting my Cisco Aironet 340 network card.  I am kind of a novice in the linux arena.  I started looking for something like DSL for this laptop when I realized Fedora was entirely too large to install on a 2gb hard drive.  I have never compiled a kernel myself, and I am not sure I am ready for such a task quite yet.  Can anyone offer me some help.  If you need any more info, please ask.  Thanks!
Back to top
Profile PM 
tempestuous Offline





Group: Members
Posts: 259
Joined: Aug. 2004
Posted: Nov. 03 2005,06:16 QUOTE

If your audio chipset is Creative Ectiva EV1398 (you should check this) it is supported by the OSS es1371  module, so -
modprobe es1371

You should also run "modinfo es1371" to check options.

The Cisco Aironet 340 is supported by the airo_cs module, so -
modprobe airo_cs

I'm not sure if iwconfig is used to set up this module, you will need to find out.  If it is, do this -
iwconfig eth0 essid MY_ESSID key 1234567890 mode managed
pump -i eth0  # (for automatic IP)
Back to top
Profile PM 
colonelpenguin Offline





Group: Members
Posts: 5
Joined: Nov. 2005
Posted: Nov. 03 2005,22:07 QUOTE

Thank you very much for your quick reply.  I am going to try your suggestions in a few hours.  Can you tell me how I could find out exactly what chipset the Solo2200 uses?  I went to gateway's site, but could find nothing that detailed.  They only get as far as replacement ram and processor speed.
Back to top
Profile PM 
tempestuous Offline





Group: Members
Posts: 259
Joined: Aug. 2004
Posted: Nov. 03 2005,23:46 QUOTE

Check the output messages after running -
lspci -v
cat /proc/interrupts (usually sound card is listed at IRQ5)
dmesg
Back to top
Profile PM 
colonelpenguin Offline





Group: Members
Posts: 5
Joined: Nov. 2005
Posted: Nov. 04 2005,05:11 QUOTE

Ok, I am going to try and type all of this out.  The only way since my laptop doesn't have a floppy drive :(.

After typing: "lspci -v"  I am prompted as follows.

0000:00:00.0 Host bridge: Intel Corp. 430MX - 82437MX Mob. System Ctrlr (MTSC) & 82438MX Data Path (MTDP) (rev 02)
    Flags: bus master, medium devsel, latency 32

0000:00:01.0 Bridge: Intel Corp. 430MX - 82371MX Mobile PCI I/O IDE Xcelerator (MPIIX) (rev 03)
    Flags: bus master, medium devsel, latency 0

0000:00:0d.0 PCMCIA bridge:  Cirrus Logic CL 6729 (rev ee)
    Flags: stepping, slow devsel
    I/O ports at fcfc [disabled] [size=4]

0000:00:14.0 VGA compatible controller: Chips and Technologies F65554 (rev c2) (prog-if 00 [VGA])
    Flags: stepping, medium devsel
    Memory at 3e000000 (32-bit, non-prefetchable) [size=16M]
    Expansion ROM at <unassigned> [disabled] [size=256K]

I got an error about that contained init_module: No such device after "modprobe es1371"

I also got an error after "modprobe airo_cs" that contained this init_module: Operation not allowed.


It appears that maybe my PCMCIA bridge is not working.  Any idea from the above info?  I guess I would like to get the network card working first so I don't have to type out the error messages :).  Thanks again for your willingness to help!
Back to top
Profile PM 
17 replies since Nov. 02 2005,22:39 < Next Oldest | Next Newest >

[ Track this topic :: Email this topic :: Print this topic ]

Pages: (4) </ [1] 2 3 4 >/
reply to topic new topic new poll
Quick Reply: Solo 2200

Do you wish to enable your signature for this post?
Do you wish to enable emoticons for this post?
Track this topic
View All Emoticons
View iB Code